Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

MoCATM Access technology can be used to deliver gigabit and multi-gigabit services to the end-user in the scope of Fiber Extension (FTTep). It has been defined as one of the the available technologies in TR-419

. MoCA has been defined by the Multimedia over Coax Alliance  (https://mocalliance.org).

...

This project  specifies a performance test plan including performance requirements for application of MoCA Access technology in coaxial access scenarios. The focus is on the Physical layer and Traffic testing similar to how TR-380 (G.fast) and TR-476 (G.hn access) performance test plans are defined.  This performance test plan will include test setup information, equipment configuration requirements, test procedures, and performance requirements for each test case. Traffic tests should show the throughput and delay for various packet sizes and mixes for the various use cases. This mix is called FASTMIX and has a predefined mix of IP packet sizes.


Frame Size (bytes)

Probability

1566

0.050

1500

0.673

1024

0.088

256

0.014

70

0.175

Note: All Ethernet frame sizes being on the first byte of the Destination MAC Address and end on the last byte of the Frame Check Sequence (FCS).

Table 1: FASTMIX Frame Size Distribution within Ethernet Traffic

The performance test use cases are based on four predefined frequency plans as used by MoCA. These frequency plans are:

  1. Two bonded MoCA Phy layers (band A-A 400-1675 MHz)
  2. Terrestrial TV overlay (band A-B 800-1675 MHz)
  3. Mobile services overlay (band A-C 1025-16775MHz)
  4. CATV+ DOCSIS 3.0 overlay (band A-D 1125-1675MHz)

The top level architecture and traffic configuration of the test platform covers both point-to-point (P2P) and point-to-multipoint (P2MP) test scenarios. In the P2MP scenario both the star and tap network are addressed. 


Image Added

Figure 1: P2P test setup


Image Added

Figure 2: P2MP test setup


The 'Physical Layer Test Setup' contains the coaxial cables, attenuators to adjust signal levels, taps and splitters to distribute the signal to the end-point(s).

This Test Plan, created by the PHYtx Work Area, provides guidance to the expected performance and Quality of Service for operators planning to deploy FTTep using MoCA in their networks.


Useful links

  • WT-500
    Jira
    serverBBF Jira
    columnIdsissuekey,summary,issuetype,created,updated,duedate,assignee,reporter,priority,status,resolution
    columnskey,summary,type,created,updated,due,assignee,reporter,priority,status,resolution
    serverIdd92875e6-bce1-3b6b-a909-e9268944d601
    keyCONTRIB-23800

  • IL
    Jira
    serverBBF Jira
    columnIdsissuekey,summary,issuetype,created,updated,duedate,assignee,reporter,priority,status,resolution
    columnskey,summary,type,created,updated,due,assignee,reporter,priority,status,resolution
    serverIdd92875e6-bce1-3b6b-a909-e9268944d601
    keyCONTRIB-23794

...